Description

AC 230 V, 50-60 Hz
For switching and dimming incandescent lamps, HV halogen lamps and LV halogen lamps using dimmable wound transformers or electronic transformers.
(Phase control and phase alignment)
With integral bus coupler, screw terminals, short-circuit, open-circuit and excess temperature protection with soft start function.
The dimming actuator automatically recognises the connected load. Combinations of ohmic and inductive, or ohmic and capacitive loads can also be connected. Combinations of inductive and capacitive loads must not be connected.
For installation on DIN rails TH35 according to EN 60715. The bus is connected using a bus connecting terminal; a data rail is not necessary.
KNX software functions: Dimming operation via KNX, extension units and on the device, different dimming curves and dimming speeds, the same dimming time, memory function, ON/OFF delay, staircase time function with/without manual OFF function, scenes (up to eight stored brightness values can be retrieved), central function, logic operation or priority control, blocking function, status feedback.
Nominal voltage: AC 110-230 V ±10%
Operating voltage: min. AC 92 V – max. AC 253 V
Mains frequency: 50/60 Hz ±2%
Nominal load
Ohmic loads: AC 110 V /50 Hz, 14-480 W
AC 230 V /50 Hz, 30-1000 W
AC 110 V /60 Hz, 14-400 W
AC 230 V /60 Hz, 30-850 W
Inductive/capacitive loads: AC 110 V /50 Hz, 24-480 VA
AC 230 V /50 Hz, 50-1000 VA
AC 110 V /60 Hz, 24-400 VA
AC 230 V /60 Hz, 50-850 VA
Input (extension unit operation): AC 110-230 V, 50/60 Hz (same phase as the dimming channel)
Device width: 4 modules = approx. 72 mm
Extension unit operation: Extension TELE insert MTN573998
Contents: With bus connecting terminal and cable cover.